How to fix a loose doorlight
If your door light is loose, not sitting properly, or falling out, the issue is usually not the light itself. The fix is
quick and easy.
What causes the problem
The door light is made to a very tight tolerance, so the usual cause is the adjustable clasp/clip on the end of the unit
being pressed in too far during installation.
When this happens, the clip sits recessed, which stops the light from fitting tightly in the door.
https://youtu.be/uGYqmq3Xc8Y
What you need
Use one of these tools:
- The pry tool included in the box
- A small flathead screwdriver
- A pair of scissors
Step-by-step instructions
1. Remove the door light
Take the light out of the door so you can inspect it properly.
2. Find the adjustable clip
Look at the end of the light unit for the clasp/clip. This is the part that may have been pushed in too far.
3. Check whether the clip is recessed
If the clip is sitting flush with or below the surface of the unit, it likely needs to be pulled outward.
4. Insert your tool under the clip
Use the pry tool, scissors, or a flathead screwdriver to gently get underneath the clip
5. Pry the clip outward
Carefully lift the clip out a little at a time until it sits slightly above the body of the light.
6. Adjust further if needed
If the fit was very loose, pull the clip out a bit more so it protrudes further from the unit.
7. Reinstall the light
Put the light back into the door and check the fit.
8. Test the tightness
Make sure the light now sits securely and does not fall out or move around.
Extra tip
If any of your other door lights also feel loose, remove them and adjust the same clip in the same way. The clip is
designed to be fully adjustable for this reason.
Result
Pulling the clip outward should fix the issue and help the door light sit tightly and securely in place.